[Speex-dev] A question in the document of wide-band encoding.

[ChengWei]

Dear Jean-Marc:

in Section Speex wideband mode (sub-band CELP), Subsection Bit
allocation of the speex manual, you pointed out that the mode ID of
wideband is 3 bits (it is consistent with the source code), however,
in the following table (Table Quality versus bit-rate for the wideband
encoder), there are 11 different modes (from 0 to 10).  I am confused
about this inconsistency, as 3 bits can only provide 0 to 7. Did I
miss something in the document? Thanks a lot in advance.

Best Regards,
Cheng Wei