[CELT-dev] CELT complexity question

[Riccardo Micci]

Hi,
I'm testing CELT 0.7.1 speed performance and I'm focusing now on the 
complexity switch. I've dug in the archive and i found some information. 
Is it still true that there are two ranges?
- 0-2 low complexity mode
- 3-10 high complexity mode
If no input is given is 2 hence low complexity mode the default setting?
Does the complexity mode affect decoding as well?

Thank you

Best Regards
Riccardo 


Riccardo Micci
Senior DSP Engineer, Wireless Group 
Cambridge Consultants
Science Park, Milton Road 
Cambridge, CB4 0DW, England
Switchboard: +44 (0)1223 420024
Direct dial: +44 (0)1223 392402
Mobile: +44 (0)
Fax: +44 (0)1223 423373
riccardo.micci at cambridgeconsultants.com
www.CambridgeConsultants.com
 





This email is from Cambridge Consultants Limited, Science Park, Milton 
Road, Cambridge CB4 0DW with registered number 1036298 England. It may 
contain confidential information. It is intended for the addressee only 
and may not be copied or disclosed to any third party without our 
permission. If you are not the intended recipient please contact the 
sender as soon as possible and delete the material from any computer. If 
this email has been sent as a personal message to the addressee, the 
sender is not acting in his/her capacity as an employee or officer of 
Cambridge Consultants Limited and no liability is accepted for the content 
of any such email. Outgoing email may be monitored for the purpose of 
ensuring compliance with our email policy and relevant laws.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.xiph.org/pipermail/opus/attachments/20100820/5ec83c1a/attachment-0002.htm