[Speex-dev] Is it possible to change the quality with encoding ?

Jozsef Vass jvass at logitech.com
Tue Oct 9 11:23:38 PDT 2012


Yes, you can change the quality while encoding. You can get all kinds
of statistics from jitter buffer (number of packets stored, etc.) and
can adjust the quality based on that. Please note that jitter buffer
is on receiving side and adjusting the quality is on sender side, so
you need to communicate your measurements to the other side.

Jozsef

On Mon, Oct 8, 2012 at 3:37 PM, Morgan <morgan at hsware.net> wrote:
> Hi All,
>
> Actually, the question is right on the topic.
>
> Is it possible to change the quality while encoding ?
>
> If the answer is yes, does the jitter buffer provides info about latency, e.g. : if latency is too high, we lower down the quality, if the latency is okay, we are raising the quality until latency rise up again...
>
> Thank you for your help.
>
> Morgan
>
>
>
> _______________________________________________
> Speex-dev mailing list
> Speex-dev at xiph.org
> http://lists.xiph.org/mailman/listinfo/speex-dev


More information about the Speex-dev mailing list