[Speex-dev] AEC learning behaviour

[Simon Morlat]

Hi,

I already implemented and posted a patch to do this serialization a few 
weeks ago.
http://permalink.gmane.org/gmane.comp.audio.compression.speex.devel/6913

It is not integrated into the main git tree though.

Regards,

Simon

On 26/05/2011 21:21, Stuart O Anderson wrote:
> This is not part of the current API.  It shouldn't be too hard add a
> serialization routine for SpeexEchoState.
>
> Stuart
>
> On Thu, May 26, 2011 at 12:07 PM, Maris Engineering<mail at maris-ee.eu>  wrote:
>>> Yes, you are not forced to reset the AEC between calls at all, if you
>>> can assume the actual echo path (physical environment) will not change
>>> much, you can keep the instance and continue using it for the next call.
>>>
>>> Also what we did was keep the AEC running between calls - but we had a
>>> rather high-duty system with sounds and signals played between calls, so
>>> the AEC almost continuously had signal to stay adapted on.
>>>
>> This is the suboptimal approach...
>>
>>> 2011.05.25. 20:29 keltez?ssel, Stuart O. Anderson ?rta:
>>>> Perhaps you could add a warm-start to the AEC, such that the parameters
>>>> start near the correct values on all but the first use?
>> ... and this is considered to be the optimum approach (for e.g. stationary
>> units).
>>
>> It is this latter which I asked in this mailing list about, some time ago,
>> without reasonable answer. Stuart, do you know if it's possible to
>> retrieve the internal state variables in order to reassign them upon
>> startint a new VoIP-connection?
>>
>> -Rob
>> _______________________________________________
>> Speex-dev mailing list
>> Speex-dev at xiph.org
>> http://lists.xiph.org/mailman/listinfo/speex-dev
>>
>>
> _______________________________________________
> Speex-dev mailing list
> Speex-dev at xiph.org
> http://lists.xiph.org/mailman/listinfo/speex-dev
>