[speex-dev] Speex for PDA

[Ryan dl]

hello,

I have recently compiled speexenc for WinCE/StrongARM
SA-1110-processor. It seems to run with no errors,
however the encoding time is very slow - 10 seconds of
speech takes aprox 3 minutes to encode. 

Even though the target architecture is significantly
less powerfull than a standard PC, I am trying to
figure out why it is this slow. Does speex use
floatpoint calculations?

The input raw data rate is 11025Hz but I don't think
this should make a difference (or does it?). I am
using VC++6 as the compiler with Handheld SDK.
 
Thanks for your help

Ryan de Leeuw

<p><p><p><p><p>__________________________________________________
Do you Yahoo!?
Yahoo! Web Hosting - Let the expert host your site
http://webhosting.yahoo.com
--- >8 ----
List archives:  http://www.xiph.org/archives/
Ogg project homepage: http://www.xiph.org/ogg/
To unsubscribe from this list, send a message to 'speex-dev-request at xiph.org'
containing only the word 'unsubscribe' in the body.  No subject is needed.
Unsubscribe messages sent to the list will be ignored/filtered.