[Paranoia] Parallel ripping causes extreme slowdowns

[Karl Heller]

What card is your hard drive on?

Also, you need to make sure your pci bus card isn’t using the same bus as the onboard  sata.  

Your mobo manual should show you what is shared or not.  Might even need to check IRQs
Sent from the kPhone

> On Mar 17, 2019, at 5:05 PM, Johannes Bauer <dfnsonfsduifb at gmx.de> wrote:
> 
> Hi again,
> 
> some more info to this. I'm using the internal SATA controller and a
> PCIE one as well:
> 
> 
> ripmachine [~]: lspci | grep -i sata
> 00:1f.2 SATA controller: Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 6
> port SATA Controller [AHCI mode] (rev 02)
> 01:00.0 SATA controller: ASMedia Technology Inc. ASM1062 Serial ATA
> Controller (rev 02)
> 
> Two drives connected to the internal Intel controller, one to the PCIE
> ASMedia controller.
> 
> When I rip concurrently on the two drives that are connected internally,
> the speed is perfect. Only when I mix the internal controller with the
> other controller the stall occurs.
> 
> If I use only the PCIE drive, it also works perfectly. Only the
> combination makes trouble.
> 
> 
> Maybe that's a hint that is somehow useful?
> 
> All the best,
> Johannes
> _______________________________________________
> Paranoia mailing list
> Paranoia at xiph.org
> http://lists.xiph.org/mailman/listinfo/paranoia