[tremor] Tremor on TI DSP c6701

[timmy brolin]

C6701 is a floating point DSP. Why don't you try the normal floating point vorbis implementation?
Tremor is primarily intended for smaller processors without support for floating point math, such as ARM.

Timmy

-----Original Message-----
From: "ope" <ope821 at hotmail.com>
To: <tremor at xiph.org>
Date: Thu, 29 Apr 2004 06:58:12 +0800
Subject: [tremor] Tremor on TI DSP c6701

Hi all:
I am a newbie to vorbis, and I want to develop vorbis decoder onto TI  c6701 evm board.
 And I try the tremor code and libvorbis and the code from http://www.xiph.org/archives/tremor/200210/0001.html .
 But all of them  stll  work good in MSVC but terrible in c6701.
I dont know wher the problem is??Problem of code or problem of memory allocation?? it decodes almost noise,....
When I trace the code I found some fit_value[] between fit_value[0] and fit_value[1] were wrong before  /* unwrap positive values and reconsitute via linear interpolation */
Then I found the wrong fit_value because of the wrong dec_firsttable[lok] value 
So it seems tth codecsetup error info ,is it ?? If it is, how can I trace deeply to fined the problem ?? Or anyone has experience on TI DSP could kindly tell me where is the problem??Any feedback would be very appreciated.
Regards Tony

<p><p>--- >8 ----
List archives:  http://www.xiph.org/archives/
Ogg project homepage: http://www.xiph.org/ogg/
To unsubscribe from this list, send a message to 'tremor-request at xiph.org'
containing only the word 'unsubscribe' in the body.  No subject is needed.
Unsubscribe messages sent to the list will be ignored/filtered.