<div dir="ltr">Hi guys,<div><br></div><div>I&#39;m using Opus for speech in wide-band mode (sampling rate 16000) and 20ms frames with signal type set to SIGNAL_VOICE.</div><div><br></div><div>I have a few questions here:</div><div><br></div><div>1.</div><div>When I choose VBR mode, the codec seems to choose the bitrate on its own.</div><div>However, that seems to be an issue on mobile devices. In some cases, when I configure the bitrate to say 20kbps, I see that the outgoing codec bitrate at runtime is sometimes far less (11-12kbps even). That leads to a lower received audio quality.</div><div>When I choose CBR mode however, the outgoing bitrate is fixed at 20kbps and produces better audio quality.</div><div><br></div><div>Is there a way to bias the VBR mode to use a value closer to the configured target bitrate or fix this low bitrate issue in any other way?</div><div><br></div><div>2.</div><div>When using CBR mode, there seems to be an issue when I use frame sizes &gt;20ms. On the receiving end, there appears to be a distortion (a crackling noise) that does not happen when using VBR mode on the encoding side (all else the same).</div><div>Has anyone experienced this and/or can suggest a fix/workaround for this issue?</div><div><br></div><div>3.</div><div>Overall, is using VBR vs CBR mode noticeably better or worse in terms of quality/bitrate? Any recommendations here?</div><div><br></div><div>Thank you!</div></div>